Need help?Do you have a question about the Stihl 4180 Series and is the answer not in the manual?
General| Engine Type | 2-stroke |
|---|---|
| Ignition system | Electronic |
| Starter | Recoil starter |
| Idle speed | 2800 rpm |
| Carburetor | Diaphragm |
Details engine displacement, bore, stroke, power, and speed specifications.
Specifies spark plug type and electrode gap.
Provides pressure test specifications for crankcase and carburetor.
Lists fasteners and their required torque values for assembly.
Lists common clutch problems, their causes, and remedies.
Addresses issues with the starter rope and rewind mechanism.
Covers troubleshooting for no spark or rough engine running.
Explains common carburetor issues like flooding or poor acceleration.
Guides on diagnosing problems like starting difficulties or erratic running.
Provides general advice on starter rope stiffness and lubrication.
Step-by-step instructions for removing and reinstalling the rewind starter assembly.
Details rotor removal, rope replacement, and spring tensioning procedures.
Instructions for replacing the rewind spring and pawl.
Procedure for removing the engine shroud.
Describes cleaning and replacing the air filter element and housing.
Covers carburetor leakage testing and removal/installation.
Details fuel pump component service, including diaphragm replacement.
Guides on servicing inlet needle, accelerator pump, and adjusting idle speed.
Provides carburetor base settings and tank vent system checks.
Overview of fuel delivery, tank cleaning, and fuel line procedures.
Procedures for compression testing and valve clearance adjustment.
Instructions for adjusting valves and servicing cam components.
Procedures for servicing the muffler, clutch, and flywheel.
Guides for servicing the crankshaft, crankcase, and piston components.
Guides on installing piston rings and servicing valves.
Procedure for performing vacuum and pressure tests on the engine.
Instructions for servicing the spark plug boot and ignition module.
Guides for testing ignition system components and using a troubleshooting flowchart.
Procedures for servicing throttle trigger, lockout lever, and cable tensioner.
Guides for adjusting throttle cable and servicing the slide control mechanism.
Instructions for removing and installing AV system components like fan housing.
To Next Page
