To Next PageTo Next Page
Need help?Do you have a question about the Stihl FC 90 and is the answer not in the manual?
General| Displacement | 28.4 cm³ |
|---|---|
| Idle speed | 2, 800 rpm |
| Spark plug | NGK CMR6H |
| Electrode gap | 0.5 mm |
| Starter | Recoil starter |
| Fuel Tank Volume | 0.5 liters |
| Ignition system | Electronic |
| Air filtration | Air filter |
| Exhaust system | Standard |
Explains the meaning of symbols attached to or embossed on the machine.
Describes how operating and safety instructions are marked with illustrations and item numbers.
Discusses STIHL's continuous product improvement and potential manual discrepancies.
Details operator requirements including physical condition and mental alertness.
Specifies necessary protective apparel for safe operation, including eye, hearing, and head protection.
Covers general safety regarding the tool, modifications, and transport.
Explains the correct fuel mixture and handling precautions for the STIHL edger.
Outlines essential pre-operation checks and safety measures before starting the engine.
Provides instructions on how to safely start the engine of the power tool.
Details safe operating practices, including holding the tool and working conditions.
Guidelines for operating the tool outdoors in well-ventilated areas with good visibility.
Steps to take before starting to use the edger, including soil and area preparation.
Instructions on how to adjust the depth wheel for the desired cutting depth.
Guidance on how to perform lawn edging, including starting the engine and cutting techniques.
Information on how to mix fuel and oil, and storage recommendations for fuel mix.
Identifies the controls on the handle for starting, stopping, and operating the engine.
Step-by-step guide for starting the engine under different temperature conditions.
Procedures for safely stopping the engine and troubleshooting if it doesn't start.
Guidelines for operating the tool outdoors in well-ventilated areas with good visibility.
Instructions for the initial break-in period of a new machine to ensure proper engine seating.
Advice for operating the tool after long periods of full throttle use.
Steps to take after completing work, including short-term storage.
Instructions on how to properly install the air filter element and cover.
Details the factory standard setting for the carburetor and initial checks.
Steps to remove the spark plug for inspection or replacement.
Detailed procedure for replacing a broken rewind spring.
Outlines the rights and responsibilities of the owner regarding the emission control system warranty.
Details the warranty coverage period and terms for emission-related parts.
Explains the owner's duty to perform required maintenance and retain receipts.
Explains California's emission control system warranty for small off-road engines.
