FC 90
English
13
N Tighten down the wingnut
clockwise.
N Standing in the normal working
position, check the depth of cut
again and correct it if necessary,
The deflector has been set at the factory
so that the arrow on the deflector and
the open side point away from the
operator. This ensures that cuttings and
other debris are directed away from the
machine and operator.
Lawn edging
N Starting the Engine
N Start the cut at no less than half
throttle and continue cutting at full
throttle.
N Hold and guide your edger so that
the blade is vertical.
N Cut steadily so that the engine is not
lugged down – do not apply force.
N Cut at no more than a normal
walking pace.
N Do not push the blade into the
ground.
N Always walk forwards when cutting,
do not pull the unit towards you.
N Edge at a steady pace to avoid
having to make several passes.
N Use the gunning sight (1) to line up
the blade on the edge.
Do not adjust the deflector.
To Next Page
Loading...
Need help?
General
