Stihl Brushcutter - Page 34

O
n
l
i
n
e
v
e
r
s
i
o
n
-
n
o
t
f
o
r
r
e
p
r
i
n
t
•
Put the unit on the ground:
It must rest securely on the engine
support and deflector. Check that
the cutting tool is not touching the
ground or any other obstacles.
•
Make sure you have a firm
footing: Hold the unit with you left
hand and press it down ILUPO\ -
your thumb should be under the dri-
ve shaft.
•
Do not stand or kneel on the drive
shaft!
•
Pull the starter grip slowly with your
right hand until you feel it engage -
and then give it a brisk strong pull.
Do not pull out starter rope more
than 70cm (27") - it might break.
Do not let the starter grip snap
back - guide it slowly into the
housing so that the starter rope
can rewind properly.
:KHQHQJLQHEHJLQVWRILUH
If HQJLQHLVFROG
•
Turn filter cover  counterclockwi-
se until mark on filter cover
points to N
continue cranking until engine runs.
If HQJLQHLVZDUP
•
Continue cranking until engine runs.
343BA032
