FC 96, FC 111
English
25
N Press the boot (2) firmly onto the
spark plug.
N Fit the cover (1) and screw it down
firmly.
For periods of 3 months or longer
N Drain and clean the fuel tank in a
well ventilated area.
N Dispose of fuel properly in
accordance with local
environmental requirements.
N Run the engine until the carburetor
is dry – this helps prevent the
carburetor diaphragms sticking
together.
N Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
N Remove, clean and inspect the
cutting blade.
N Store the machine in a dry, high or
locked location, out of the reach of
children and other unauthorized
persons.
Have a worn depth wheel replaced by a
servicing dealer. STIHL recommends
that you have servicing and repair work
carried out exclusively by an authorized
STIHL servicing dealer.
Depth Wheel
N The end of the thread on the
screw (1) is peened over to ensure
that the wingnut (2) does not work
loose and be lost.
A very high torque has to be applied to
remove the wingnut from the screw. If
the parts are then reassembled, the
captive function is no longer
guaranteed. In such a case have the
screw and wingnut replaced by a
servicing dealer.
Storing the Machine Replacing the Depth Wheel
To Next Page
Loading...
