Stihl FC 96 - Checking and Replacing the Wear Guard

FC 96, FC 111
English
27
Checking the Wear Guard
N Check the wear guard (1) for
damage before starting the power
tool.
N The wear guard must be replaced
as soon as the gearbox (2) (arrow)
becomes visible.
NOTICE
The gearbox may be seriously damaged
if you do not replace the wear guard in
good time.
Replacing the Wear Guard
N Remove the cutting blade - see
"Mounting the Cutting Blade".
N Remove the thrust plate (3).
N Take out the screws (4).
N Fit the new wear guard (5).
N Insert the screws (4) and tighten
them down firmly.
N Fit the thrust plate (3).
N Mount the cutting blade - see
"Mounting the Cutting Blade".
Checking and Replacing the
Wear Guard
2
257BA017 KN
1
4
5
257BA018 KN
4