Stihl FS 100 Instruction Manual

FS 100, FS 100 R
English
25
N Loosen the screw (3).
Balancing the brushcutter
The unit is balanced differently,
depending on the cutting attachment
used.
Proceed as follows until the conditions
specified under "Floating positions"
have been met:
N Adjust the carrying ring.
N Tighten the screw moderately.
N Allow the unit to hang freely.
N Check the position obtained.
Floating positions
Mowing tools (A) such as mowing
heads, grass cutting blades and brush
knives
N should just touch the ground.
Circular saw blades (B)
N should "hover" about 20 cm (8 in)
above the ground.
When the correct floating position has
been reached:
N Tighten down the screw on the
carrying ring firmly.
Detaching the unit from the harness
N Press down the bar on the
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
A
002BA034 KN
B
002BA035 KN

Stihl FS 100 Specifications

General

Brand	Stihl
Model	FS 100
Category	Engine
Language	English