88 FS 240 C, FS 260 C, FS 360 C, FS 410 C, FS 460 C-M
: Slide throttle trigger (1) onto
post (3)
: Slide lever (2) into the throttle
trigger (1) so that the lever
(arrow) rests against the stud
: Turn the trigger interlock (1)
slightly and push the throttle
trigger on further until it engages
the trigger interlock
: Slide torsion spring (1) onto
throttle trigger and secure it with
the anchor loop on the cylindrical
raised part (arrow)
5904RA315 TG
1
3
2
5904RA316 TG
1
5904RA317 TG
1
: Turn torsion spring clockwise and
hook it into the lever (arrow)
Ground wire and short circuit wire
must be inserted completely in the
guides (arrows).
: Route throttle cable (1) and
protective tube (2) in the guides
(arrows) and hold in place
5904RA318 TG5904RA319 TG5904RA320 TG
1
2
– Carefully fit handle molding (1)
until it snaps into place
– Levers may pop out
: Insert and tighten down the
screws (arrows)
Checking operation
When the trigger interlock (1) is not
pressed, the throttle trigger (2) is
blocked and must not move.
: Release throttle trigger (2) – the
throttle trigger must return
completely to the stop
5904RA321 TG
1
5904RA322 TG
1
2
To Next Page
Loading...
Need help?
General
