EasyManuals Logo

Stihl FS 45 User Manual

Stihl FS 45
92 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #26 background imageLoading...
Page #26 background image
FS 45, FS 46
English
24
N Set the choke lever to e .
N Move the stop switch to I, interlock
lever and throttle trigger to the
starting throttle position.
N Start the engine by pulling the
starter rope briskly – 10 to 20 pulls
may be necessary.
If the engine still does not start
N Move the stop switch to 0.
N Remove the spark plug – see
"Spark Plug".
N Dry the spark plug.
N Crank the engine several times with
the starter to clear the combustion
chamber.
N Refit the spark plug – see "Spark
Plug".
N Move the stop switch to I.
N Set the choke lever to e – even if
the engine is cold.
N Now start the engine.
Fuel tank run until completely dry
N After refueling, press the fuel pump
bulb at least five times – even if the
bulb is filled with fuel.
N Set the choke lever to suit the
engine temperature.
N Start the engine.
During break-in period
A factory-new machine should not be
run at high revs (full throttle off load) for
the first three tank fillings. This avoids
unnecessary high loads during the
break-in period. As all moving parts
have to bed in during the break-in
period, the frictional resistances in the
engine are greater during this period.
The engine develops its maximum
power after about 5 to 15 tank fillings.
During Operation
After a long period of full throttle
operation, allow the engine to run for a
short while at idle speed so that engine
heat can be dissipated by the flow of
cooling air. This protects engine-
mounted components (ignition,
carburetor) from thermal overload.
After Finishing Work
Storing for a short period: Wait for the
engine to cool down. Empty the fuel tank
and keep the machine in a dry place,
well away from sources of ignition, until
you need it again. For longer out-of-
service periods – see "Storing the
Machine".
If there is a noticeable loss of engine
power
N Set the choke lever to g.
N Press in the tab (1) and swing the
filter cover (2) down.
N Clean away loose dirt from around
the filter.
Operating Instructions Cleaning the Air Filter
232BA017 KN
1
2

Other manuals for Stihl FS 45

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stihl FS 45 and is the answer not in the manual?

Stihl FS 45 Specifications

General IconGeneral
Engine Displacement27.2 cc
Power Output0.75 kW
Cutting Diameter380 mm
Engine Type2-stroke
Shaft TypeCurved
Fuel Capacity0.33 liters
Fuel Tank Capacity0.33 liters
Cutting Width380 mm
Engine Power1.0 bhp
Vibration Levels Left/Right Handle5.5/5.5 m/s²

Related product manuals