Stihl FS 80 - Page 32

31FS 80, FS 80 R, FS 85, FS 85 R
English
Shoulder strap*
: Put on the shoulder strap (1).
: Adjust the length of the strap so that
the spring hook (2) is about 2” below
your right hip.
: Balance the brushcutter.
The use of the harness is described in
chapter “Approved Combinations of
Cutting Tool, Deflector, Handle and
Harness”.
* see “Guide to Using this Manual”
Full harness*
: Put on the full harness (1).
: Adjust length until the spring hook
(2) is about a hand’s width below
your right hip.
: Balance the brushcutter.
The use of the harness is described in
chapter “Approved Combinations of
Cutting Tool, Deflector, Handle and
Harness”.
* see “Guide to Using this Manual”
Attaching the unit to the shoulder
strap
: Attach the spring hook (1) to the
carrying ring (2) on the drive tube.
Fitting the Harness Balancing the Brushcutter