Stihl FS56 - Transporting the Unit; Using transport guard; Fitting the transport guard

FS 56, FS 56 R, FS 56 C, FS 56 RC
English
27
When the correct floating position has
been reached:
N Tighten down the screw on the
carrying ring firmly.
Detaching the unit from the harness
N Press down the bar on the
carabiner (1) and pull the carrying
ring (2) out of the carabiner.
Controls
Version with bike handle
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and 0 = Stop
positions.
Version with loop handle
1 Throttle trigger lockout
2 Throttle trigger
3 Stop switch with Run and 0 =Stop
positions.
Function of stop switch and ignition
system
The stop switch is normally in the Run
position, i.e. when it is not depressed:
The ignition is switched on – the engine
is ready to start. If the stop switch is
moved to the 0 position, the ignition is
switched off. The ignition is switched on
again automatically after the engine
stops.
1
2
1
2
002BA312 KN
Starting / Stopping the
Engine
1
002BA268 KN
2
3
002BA269 KN
1
3
2