To Next PageTo Next Page
Need help?Do you have a question about the Stihl FS56 and is the answer not in the manual?
General| Engine Type | 2-stroke |
|---|---|
| Displacement | 27.2 cc |
| Power Output | 0.8 kW |
| Engine Power | 0.8 kW |
| Weight | 5.2 kg |
| Shaft Type | Straight |
| Fuel Tank Volume | 340 ml |
| Starter | Recoil starter |
| Vibration Level | 4.5 m/s² |
Explains symbols attached to or embossed on the machine.
Explains how steps and procedures are marked in the manual.
Notes that product improvements may not be covered.
Details operator's physical and mental condition, and proper clothing for safe operation.
General information and warnings about the tool itself.
Safety guidelines for carrying the tool.
Lists available mowing heads and metal cutting attachments.
Describes types of deflectors and their approved uses.
Details different types of handles available.
Explains the types of harnesses and straps.
Step-by-step instructions for attaching the handlebar.
Procedure for installing the control handle assembly.
How to align and tighten the handlebar.
Steps for installing the barrier bar.
How to position and tighten the loop handle.
Instructions for fitting the carrying ring on bike handle models.
Carrying ring is integrated on loop handle models.
Guidance on choosing the correct deflector for attachments.
Instructions for attaching the deflector to the gearbox.
Process of installing the thrust plate on the shaft.
Details on hardware included with attachments.
Advice on mixing fuel and oil, and storage duration.
Steps to safely open the fuel tank cap.
Safety precautions and process for adding fuel.
Steps to securely close the fuel tank cap.
Instructions for wearing and adjusting the shoulder strap.
Instructions for wearing and adjusting the full harness.
How to connect the tool to the harness.
Adjusting the tool for optimal balance during use.
Identifies and explains the function of engine controls.
Explains how the stop switch and ignition system operate.
Step-by-step procedure for starting a cold engine.
Step-by-step procedure for starting a warm engine.
General procedure for cranking the engine.
Guidance on the use of the transport guard.
Instructions for attaching the transport guard.
Guidelines for the initial use of the new machine.
Instructions for normal operation of the tool.
Procedures to follow after completing work.
Troubleshooting step involving air filter cleaning.
Procedures for adjusting the engine's idle speed.
Steps for safely removing the spark plug.
How to inspect the spark plug for issues.
Steps for installing a spark plug.
Detailed instructions for long-term storage.
How to balance blades after sharpening for safe operation.
Instructions for replacing the cutting line.
Instructions for replacing cutting blades.
A table outlining maintenance tasks and frequencies.
Visual checks, replacement, and tightness of cutting attachments.
Sharpening procedures for metal cutting attachments.
Technical details about the engine's specifications.
Specifies the weight of different tool versions.
Outlines the owner's responsibilities under the warranty.
Details the owner's duties for maintaining warranty coverage.
Owner's obligations for California warranty coverage.
Owner's duties for maintaining California warranty coverage.
