Stihl FS56 - Mounting the Cutting Attachment; Fitting the Thrust Plate; Mounting Hardware for Cutting Attachments

FS 56, FS 56 R, FS 56 C, FS 56 RC
English
19
N Fit the square nuts (1) in the barrier
bar (2); the holes must line up.
N Place the clamp (3) in the loop
handle (4) and position them both
against the drive tube (5).
N Position the clamp (6) against the
drive tube.
N Place the barrier bar (2) in position
as shown.
N Line up the holes.
N Insert the screws (7) in the holes
and screw them into the barrier bar
as far as stop.
N Go to "Adjusting and Securing the
Loop Handle".
Leave the barrier bar permanently
mounted to the loop handle.
Adjusting and Securing the Loop Handle
N Secure the loop handle (4) about
15 cm/6 in (A) forward of the control
handle (9).
N Line up the loop handle.
N Tighten down the screws firmly –
lock the nuts if necessary.
2
002BA098 KN
1
1
5
2
4
002BA589 KN
3
6
7
7
10
9
4
002BA147 KN
A