FSA 65, FSA 85
English
17
If the red light emitting diodes glow
continuously / flash
The light emitting diode (1) on charger
glows continuously green or flashes red.
Green continuous light ...
... indicates the following:
The battery
– is being charged
– is too hot and must cool down
before charging
See also "Light Emitting Diodes (LEDs)
on Battery".
The green light emitting diode on the
charger goes off as soon as the battery
is fully charged.
A 1 light emitting
diode glows con-
tinuously red:
Battery is too
hot
1) 2)
/cold
1)
1)
When charging: Charge process
starts automatically after the battery
has cooled down / warmed up.
B 4 light emitting
diodes flash red
Malfunction in
battery
3)
C 3 light emitting
diodes glow con-
tinuously red:
Power tool is too
hot – allow it to
cool down.
D 3 light emitting
diodes flash red
Malfunction in
power tool
4)
2)
During operation: Power tool cuts
out – allow battery to cool down; it
may be necessary to take the
battery out of the power tool for this
purpose.
3)
Electromagnetic problem or fault
Defekt. Take the battery out of the
power tool and refit it. Switch on the
power tool – if the LEDs continue to
flash, the battery is faulty and must
be replaced.
4)
Electromagnetic problem or fault.
Take the battery out of the power
tool and refit it. Switch on the power
tool – if the light emitting diodes still
flash, the power tool is faulty and
must be checked by a servicing
dealer – STIHL recommends an
authorized STIHL servicing dealer.
Light Emitting Diodes (LED)
on Charger
To Next Page
Loading...
