0478 216 9907 C - EN
42
Please always observe the following
important information for the prevention of
damage or excessive wear to your STIHL
machine:
1. Wearing parts
Some parts of the STIHL machine are
subject to normal wear even when used
properly and must be replaced in due time
depending on type and duration of use.
These include:
–Blade
–Blade disc
–V-belt
2. Compliance with the information in
this instruction manual
The STIHL machine must be used,
maintained and stored with the care
described in this instruction manual. Any
damage caused by non-compliance with
the safety, operating and maintenance
instructions is the sole responsibility of the
user.
This applies in particular to:
– Improper use of the product.
– Use of fuel and lubricants not approved
by STIHL (lubricants, petrol and engine
oil, see engine instruction manual).
– Product modifications not approved by
STIHL.
– The use of attaching parts, attachments
or cutting tools not approved by STIHL.
– Use of the product for sporting or
competitive events.
– Resultant damage due to continued use
of the product with defective
components.
3. Maintenance operations
All operations listed in the section
"Maintenance" must be performed
regularly.
If these maintenance operations cannot be
carried out by the user, a specialist dealer
must be commissioned to perform them.
STIHL recommends that you have
maintenance operations and repairs
performed exclusively by a STIHL
specialist dealer.
STIHL specialist dealers regularly attend
training courses and are provided with
technical information.
If these operations are neglected, faults
may arise which are the responsibility of
the user.
These include:
– Corrosive and other resultant damage
caused by incorrect storage.
– Damage and resultant damage due to
the use of spare parts which are not
original STIHL parts.
– Damage due to maintenance and repair
operations not performed in the
workshops of authorised specialist
dealers.
Blade disc assembly
6903 700 5101
Reversible blade (2x)
6903 702 0101
V-belt
6001 704 2100
Shredding material should be
composted and not disposed of
in household waste.
The machine, its packaging and
accessories are all produced
from recyclable materials and must be
disposed of accordingly.
By disposing of materials separately, and
in an environmentally friendly manner,
valuable resources can be re-used. For
this reason, the machine should be
disposed of for recycling at the end of its
useful life.
16.1 Petrol garden shredder
(STIHL GH)
STIHL Tirol GmbH
Hans Peter Stihl-Strasse 5
6336 Langkampfen
Austria
declares under our sole responsibility that
the machine
shredding machine for plant trimmings
with petrol engine (STIHL GH)
conforms to the following EC directives:
2011/65/EU, 2000/14/EC, 2014/30/EU,
2006/42/EC
14. Standard spare parts
15. Environmental protection
16. EU - Declaration of
conformity
manufacturer's
brand:
STIHL
type: GH 370.0 S
serial number 6001
To Next Page
Loading...
