Need help?Do you have a question about the Stihl HL 95 and is the answer not in the manual?
Emphasizes reading the manual and observing safety regulations for safe operation.
Details on handling gasoline safely, fueling in ventilated areas, and checking for leaks.
Ensures the tool is assembled, in good condition, and controls are functional.
Step-by-step guide to start the engine safely and correctly.
How to hold the tool firmly with both hands for secure control.
How to immediately switch off the engine in case of danger.
Guidance on safe cutting angles, checking surroundings, and avoiding hazards.
Importance of proper ventilation and avoiding toxic exhaust fumes.
Keeping hot parts away from flammable materials and not smoking.
Warnings about touching blades while running or jammed.
Regular checks for condition, tightness, cracks, and sharpness.
Cleaning plant residue and lubricant to prevent fire risk.
Advising professional servicing and use of genuine parts.
How to perform a horizontal cut using the cutter bar in an arc.
How to perform a vertical cut with the cutter bar at an angle.
Technique for vertical cuts with a straight cutter bar for long reach.
Technique for overhead cuts, with a warning about tiring positions.
Technique for horizontal cuts with a straight cutter bar at a slight angle.
Specifies the need for a gasoline and engine oil mixture.
Details the 50:1 mix ratio for gasoline and STIHL 2-stroke oil.
Safe procedures for filling the fuel tank without spilling.
How to adjust the cutter bar angle on the 135° version.
Step-by-step guide to start the engine using choke and throttle.
How to use the choke knob for cold and warm starts.
How to push the slide control to STOP-0 to stop the engine.
Steps to clean the air filter for optimal engine performance.
Adjusting the idle speed screw for smooth engine operation.
How to lubricate the blade drive gear with STIHL gear lubricant.
How to lubricate the angle drive gear with STIHL gear lubricant.
When and how to resharpen cutting blades for optimal performance.
Table outlining maintenance tasks and intervals for various components.
Details on displacement, bore, stroke, and engine power ratings.
To Next Page
General
