HLA 65
English
4
Most STIHL power tools are available
with an anti-vibration ("AV") system
designed to reduce the transmission of
vibrations created by the machine to the
operator's hands. An AV system is
recommended for those persons using
power tools on a regular or sustained
basis.
– Wear gloves and keep your hands
warm.
– Keep the AV system well
maintained. A power tool with loose
components or with damaged or
worn AV elements will tend to have
higher vibration levels.
– Maintain a firm grip at all times, but
do not squeeze the handles with
constant, excessive pressure. Take
frequent breaks.
All the above-mentioned precautions do
not guarantee that you will not sustain
whitefinger disease or carpal tunnel
syndrome. Therefore, continual and
regular users should closely monitor the
condition of their hands and fingers. If
any of the above symptoms appear,
seek medical advice immediately.
Proper Clothing
WARNING
To reduce the risk of injury, the operator
should wear proper protective apparel.
WARNING
To reduce the risk of
injury to your eyes never
operate your power tool
unless wearing goggles
or properly fitted
protective glasses with
adequate top and side protection
complying with ANSI Z 87.1 (or your
applicable national standard). Wear an
approved safety hard hat when there is
a risk of head injury.
STIHL recommends the use of sound
barriers (ear plugs or ear mufflers) to
protect your hearing.
Avoid loose-fitting jackets, scarfs,
neckties, jewelry, flared or cuffed pants,
unconfined long hair or anything that
could become caught on branches,
brush or the moving parts of the unit.
Secure hair so it is above shoulder level.
THE POWER TOOL
For illustrations and definitions of the
power tool parts see the chapter on
"Main Parts."
WARNING
Never modify this power tool in any way,
since this may increase the risk of
personal injury. Only attachments
supplied by STIHL or expressly
approved by STIHL for use with the
specific STIHL model are authorized.
Although certain unauthorized
attachments are useable with STIHL
power tools, their use may, in fact, be
extremely dangerous.
If your power tool is subjected to
unusually high loads for which it was not
designed (e.g. heavy impact or a fall),
always check that it is in good condition
before continuing work – see also
"Before Starting Work." Make sure the
safety devices are working properly. Do
not continue operating your power tool if
it is damaged. In case of doubt, have the
machine checked by your STIHL
servicing dealer.
Battery
WARNING
Improper use or handling
of the battery may result
in a risk of fire, explosion
and/or burns, including
chemical burns. Do not
disassemble, crush, heat
above 212 °F (100 °C), expose to fire or
incinerate. Never expose the battery to
microwaves or high pressures.
Do not place the battery on or near fires,
stoves or in other high-temperature
locations. Do not place the battery in
direct sunlight or store it inside a vehicle
in hot weather. Doing so may cause the
battery to generate heat, rupture or
Clothing must be sturdy
and snug-fitting but allow
complete freedom of
movement. Wear long
pants made of heavy
material to help protect
your legs. Do not wear
shorts.
Good footing is very
important. Wear sturdy
boots with nonslip soles.
Never wear sandals, flip-
flops or go barefoot.
Always wear gloves
when handling the
machine and the cutting
tool. Heavy-duty, nonslip
gloves improve your grip
and help to protect your
hands.
To Next Page
Loading...
Need help?
General
