HS 45
English
16
If there is a noticeable loss of engine
power
N Move the choke lever to l.
N Press in the tab (1) and swing the
filter cover (2) down.
N Clean away loose dirt from around
the filter.
N Remove the foam element (3) and
felt element (4).
N Wash the foam element in a clean,
non-flammable solution (e.g. soapy
water) and then dry.
N Fit a new felt element. As a
temporary measure you can knock it
out on the palm of your hand or blow
it out with compressed air. Do not
wash.
N Replace any damaged parts.
N Fit the foam element (3) in the filter
cover (2) and the felt element (4) in
the filter housing (5).
N Close the filter cover so that it snaps
into position.
Exhaust emissions are controlled by the
design of the fundamental engine
parameters and components (e.g.
carburation, ignition, timing and valve or
port timing) without the addition of any
major hardware.
Cleaning the Air Filter
To Next Page
Loading...
