To Next PageTo Next Page
Need help?Do you have a question about the Stihl HS 85 and is the answer not in the manual?
Explanation of symbols used on the machine and in the manual for clarity.
How steps or procedures are marked in text with direct or indirect illustration references.
Details on components not installed in all models, marked with an asterisk (*).
Information on product improvements and contacting dealers for changes.
Requirements for the operator's physical and mental health, including alertness and medical considerations.
General guidelines for operating the hedge trimmer, referring to 'Parts and Controls'.
Safety instructions for carrying and transporting the hedge trimmer to prevent injury.
Instructions on safely fueling the hedge trimmer, emphasizing ventilation and spill prevention.
Guidelines for operating in safe conditions, including visibility, terrain, and pre-work inspection.
Overview of maintenance, repair responsibilities, and warranty implications for replacement parts.
Adherence to country-specific and local regulations for hedge trimming.
Steps before work, including animal safety and cutting thick branches.
Recommended order for cutting hedges: sides first, then the top.
Instructions for vertical cuts on hedge sides, describing blade movement.
Recommendations for mixing fuel, storage duration, and disposal of containers.
Detailed steps for fueling, including cleaning and pressure release precautions.
Procedure for warming up the engine in very cold conditions.
Steps to take if the engine fails to start, including checking the choke and flooding.
Procedure for adjusting idle speed for proper engine idling and blade stoppage.
Troubleshooting guide if cutting blades continue to run at idle speed.
Detailed steps for replacing a broken rewind spring in the starter mechanism.
Procedure for tensioning the rewind spring after installation for proper function.
Guidelines for operating a new machine during its initial break-in period to ensure longevity.
Recommendations for engine cooling after prolonged operation to prevent thermal overload.
Steps to take after finishing work, including cooling, draining, and storage.
Explanation of warranty start dates and coverage for warranted parts.
Owner's responsibility for costs if tested machine is found non-defective.
How STIHL handles repairs, use of approved parts, and liability for component failures.
Procedure for presenting the product and warranty card to an authorized STIHL service center.
How recommended fuel mix affects maintenance intervals and the impact of deviations.
Exclusions from warranty coverage, such as misuse, neglect, or improper maintenance.
General
