Condition LEDs on
Battery
Cause Remedy
► If the LEDs still flash, do not attempt to use.
The hedge trimmer has a malfunction and must
be checked by a servicing dealer.
Cutting blades
are not clean
and lubricated.
►
Clean the cutting blades, 20.2.
►
If the LEDs still flash, do not attempt to use.
The hedge trimmer has a malfunction and must
be checked by a servicing dealer.
Hedge trimmer
cuts out during
operation.
1 LED glows
red.
Battery too hot /
too cold.
►
Remove the battery,
13.2.
►
Allow the hedge trimmer and battery to cool
down gradually at ambient temperatures of
about 50 °F to 68 °F (10 °C to 20 °C).
3 LEDs glow
red.
Hedge trimmer
too hot.
Run-time is too
short.
Battery not fully
charged.
►
Charge the battery,
10.
Useful life of bat‐
tery has been
reached or
exceeded.
► Have the battery checked by an authorized
STIHL servicing dealer.
Battery is not
being charged
even though LED
on charger glows
green.
1 LED glows
red.
Battery too hot /
too cold.
► Allow the battery to warm up or cool down grad‐
ually at ambient temperatures of about 50 °F to
68 °F (10 °C to 20 °C).
►
Operate the charger only in enclosed, dry rooms
at ambient temperatures of 41 °F to 104 °F
(5 °C to 40 °C).
23 Specifications
23.1 STIHL HSA 100
–
Approved battery types:
–
STIHL AR series
–
STIHL AP series
–
Weight without battery: 8.2 lbs. (3.7 kg)
For technical information regarding the STIHL
AR and AP series batteries, see the product
information accompanying your battery.
For technical information regarding the STIHL
AL 101, 301, 301-4 and 500 series chargers, see
the product information accompanying your
charger.
Batteries, chargers and other accessories sold
separately. Contact your authorized STIHL serv‐
icing dealer for pricing and availability.
23.2 Cutting Blades
–
Tooth spacing: 1.3 in. (34 mm)
–
Cutting length: 24 in. (600 mm)
–
Sharpening angle: 35°
23.3 Symbols on the Hedge Trim‐
mer
Symbol Explanation
V Volt
Symbol Explanation
DC Direct current
IPX4 Protection against spraying or splash‐
ing water from all directions.
Filler hole for gear lubricant.
STIHL products must not be disposed
of in the household trash, but only in
accordance with local, state and fed‐
eral laws and regulations and as pro‐
vided in this manual,
25.
23.4 Engineering Improvements
STIHL's philosophy is to continually improve all
of its products. As a result, engineering changes
and improvements are made from time to time.
Therefore, some changes, modifications and
improvements may not be covered in this man‐
ual. If the operating characteristics or the appear‐
ance of your machine differs from those descri‐
bed in this manual, please contact your STIHL
dealer or the STIHL distributor in your area for
assistance.
23.5 FCC 15 Compliance Statement
This device complies with part 15 of the FCC
Rules.
23 Specifications English
0458-020-8601-A 25
To Next Page
Loading...
Need help?
General
