4.5.2 Vertical Cut (with cutter bar at an
angle)
Cutting without standing directly next to the
hedge, e.g. flowerbed between operator and
hedge.
Swing the cutter bar up and down in an arc as
you move along the hedge – use both sides of
the cutting blades.
4.5.3 Vertical Cut (with straight cutter bar)
Extra long reach without the need for other aids.
Swing the cutter bar up and down in an arc as
you move along the hedge – use both sides of
the cutting blades.
4.5.4 Overhead Cut (with cutter bar at an
angle)
4 Using the Unit English
0458-401-0121-E 7