Stihl KGA 770 - Switching Off; After Finishing Work; Removing; Emptying Hopper; Removing the Battery

KGA 770
English
43
If the overload cutout has interrupted the
power supply:
N Switch off the machine – position 0 –
and remove the battery.
N Remove blockage from side brooms
or roller brush.
N Wait about 30 seconds for overload
cutout to cool down.
The thermal overload cutout for the side
brooms resets automatically, while the
overload cutout for the roller brush has
to be reset manually by pressing the
switch (1).
N Fit the battery and switch the
machine on again – set on/off switch
to I.
N Switch off the machine – position 0
Always remove the battery from the
power tool during work breaks and after
finishing work.
Removing the Battery
N Press in both locking tabs (1) at the
same time to unlock the battery (2).
N Take the battery (2) out of the
housing.
When the power tool is not in use, shut it
off so that it does not endanger others.
Secure it against unauthorized use.
Removing / Emptying Hopper
N Fold the push handle forwards.
N Pull hopper handle upwards.
9933BA025 KN
1
Switching Off
9933BA014 KN
1
9933BA015 KN
2
1
After Finishing Work
9933BA008 KN
9933BA016 KN