Stihl RE 80 - User Manual

Questions and Answers

D
Derrick HenryAug 13, 2025
What to do if my Stihl Pressure Washer does not start?
- R
  ryanloweAug 13, 2025
  If your Stihl pressure washer doesn't start even when you squeeze the spray gun trigger, several things could be happening. First, ensure the mains plug of the connecting cable or extension cord is properly plugged in. Also, check the circuit-breaker (fuse) or the residual current circuit breaker, and reset it if it has tripped, addressing the cause of the trip. Make sure the socket's fuse rating is correct and that the extension cord has an adequate cross-section and correct length. Finally, the electric motor may be too warm; allow the pressure washer to cool for 5 minutes and clean the nozzle.
C
Chad AlexanderAug 16, 2025
Why does my Stihl Pressure Washer keep turning off?
- M
  Mario JonesAug 16, 2025
  If your Stihl pressure washer switches off during operation, check that the plug of the connecting cord or extension cord hasn't been pulled out of the socket, and plug it back in if it has. Also, the circuit-breaker (fuse) or the residual current circuit breaker may have tripped due to an electrical overload or fault. Find the cause, remedy it, and then re-engage the breaker. Try switching off other appliances connected to the same circuit.
T
Thomas GarzaAug 20, 2025
How to fix a Stihl Pressure Washer that buzzes but doesn't start?
- D
  Dr. Amber Meyers DVMAug 20, 2025
  If your Stihl pressure washer does not start and the electric motor buzzes, it could be due to a few reasons. The mains voltage might be too low, so squeeze and hold the spray gun trigger while switching on the pressure washer and switch off other loads connected to the same circuit. Also, the extension cord might have an incorrect cross-section or be too long, so use an extension cord with an adequate cross-section and the correct length.
F
feliciamasseyAug 25, 2025
Why does my Stihl Pressure Washer pump cycle on and off?
- A
  Ashley WilliamsAug 25, 2025
  If the high-pressure pump on your Stihl pressure washer repeatedly switches on and off without you squeezing the spray gun trigger, it could indicate a leak in the high-pressure pump, high-pressure hose, or spray attachment. In this case, have a STIHL servicing dealer inspect the pressure washer.
K
katherinehowellAug 27, 2025
Why is my Stihl Pressure Washer not drawing detergent?
- B
  brittanymooreAug 27, 2025
  If the detergent additive is not being drawn into your Stihl pressure washer, first check if the container is empty and fill it with detergent if needed. If the container is full, the nozzle of the spraying set may be blocked, so clean it.
H
Harold HinesAug 31, 2025
Why is the pressure fluctuating on my Stihl Pressure Washer?
- Z
  zlopezAug 31, 2025
  If the working pressure of your Stihl pressure washer fluctuates or drops, first ensure that the water tap is fully open and that a sufficient quantity of water is available. Next, check the nozzle, water intake screen, and water filter for blockages, and clean them if necessary. If the issue persists, a STIHL servicing dealer should inspect the high-pressure pump, high-pressure hose, or spray attachment for leaks or faults.
B
buckmarvinSep 4, 2025
Why has the water jet shape changed on my Stihl Pressure Washer?
- T
  tina89Sep 4, 2025
  If the shape of the water jet from your Stihl pressure washer has changed, the nozzle is likely blocked or worn. Try cleaning the nozzle first. If that doesn't solve the problem, you may need to fit a new nozzle.
C
Christopher HernandezSep 8, 2025
How to fix stiff connections on my Stihl Pressure Washer?
- T
  thomaschristianSep 8, 2025
  If connections with your Stihl pressure washer, high-pressure hose, spray gun, or spray lance are stiff, the gaskets of the connections may not have been greased. Lubricate the gaskets.