0458-001-9621-A
60
English
11 Operating the pressure washer
11.2 Squeezing and locking the spray gun trigger
Pressing the spray gun trigger
► Move the retaining latch (1) to the position.
► Press and hold the trigger (2).
The high-pressure pump starts up automatically and water
flows out of the nozzle.
Locking the spray gun trigger
► Release the trigger (2).
The high-pressure pump switches off automatically and
water stops flowing out of the nozzle. The high-pressure
washer is still switched on.
► Move the retaining latch (1) to the position.
11.3 Cleaning
According to the application, the following nozzles can be
used:
– Fan-jet nozzle: The fan-jet nozzle is designed for cleaning
large areas.
– Rotary nozzle: The rotary nozzle is designed for removing
stubborn dirt.
The user can work close up to the surface in order to remove
stubborn dirt.
The user can work at a distance when cleaning any of the
following surfaces:
– Painted surfaces
– Wooden surfaces
– Rubber surfaces
The fan-jet nozzle is adjustable.
Turning the fan-jet nozzle in the + direction increases the
working pressure.
Turning the fan-jet nozzle in the – direction reduces the
working pressure.
► Before starting work, direct the water jet at an
inconspicuous area of the surface and check that the
surface does not suffer damage.
► Select the distance between the nozzle and the surface to
be cleaned so that the surface to be cleaned is not
damaged.
2
1
0000097568_002
2
1
0000097575_002
0000-GXX-4628-A0
To Next Page
Loading...
