MS 171, MS 181, MS 181 C, MS 211, MS 211 C
English
37
Winter shutter (MS 211 only)
At temperatures below +50°F (+10°C):
N Remove the shroud – see "Shroud".
N Use the combination wrench to turn
the shutter, next to the spark plug,
45° counterclockwise.
N Install the shroud – see "Shroud".
Heated air is now drawn in from around
the cylinder to warm the carburetor – this
helps prevent carburetor icing.
NOTICE
At temperatures above +68°F (+20°C),
return the shutter to the summer
position. This is necessary to avoid
engine running problems and
overheating.
Fitting the cover plate
(Special accessory, not for Easy2Start
models)
N Place the cover plate (1) in position
and secure it with the screws (2).
N If your saw is very cold, start the
engine and run it until it reaches
normal operating temperature.
MS 211 only: When the cover plate is
fitted, the winter shutter may be in either
the winter or summer positions. Move it
to the winter position when temperatures
drop below +50°F (+10°C).
Versions with Easy2Start
WARNING
This machine is extremely simple and
easy to start, even for children.
To reduce the risk of serious or fatal
injury:
– do not allow children or other
unauthorized persons to attempt to
start or otherwise use the machine
– never allow children or
unauthorized persons access to the
machine
– never leave the machine
unattended while working or during
work breaks
– after work, store in a safe, secure
location out of the reach of children
and other unauthorized persons
Winter Operation
1 Winter operation
2 Summer operation
Starting / Stopping the
Engine
To Next Page
Loading...
Need help?
General
