Stihl MS 192 T - Diagnosis; Warranty Work; Where to Make a Claim for Warranty Service; Limitations

56 MS 192 T
Machines with standard starter
grip
: Thread the new rope (1) through
the side of the starter grip.
1
217RA255 TG
: Pull the rope out and continue
threading it into the starter grip
from the top.
217RA256 TG
: Pull the rope through the grip until
the knot at the end of the rope is
in the recess (arrow).
217RA257 TG
Machines with ElastoStart starter
grip
: Prise off the cap (1) with a
suitable tool.
217RA353 TG
1
: Pull the rope or remaining rope
(1) out of the sleeve.
217RA354 TG
1
: Pull the rope (1) through the
sleeve into the starter grip.
– Tie a special knot in the end of
the rope.
217RA355 TG
1
: Pull the rope (1) with spring and
sleeve into the starter grip.
– Press the cap into the starter grip.
217RA356 TG
1
: Then thread the rope (1) through
the opening (arrow).
217RA252 TG
1
: Thread the rope (1) into the rope
rotor (arrows).
217RA253 TG
1