67MS 192 T
– Pull the front handle with handle
housing down slightly.
: Pull the bearing plug out of the
engine housing.
217RA162 TG
: Remove the tank vent (1).
217RA316 TG
1
: Push the fuel return line (1) out.
217RA300 TG
1
: Disconnect the tank vent (1) from
the fuel hose (2).
– Draw the fuel hose (2) out
through the opening (arrow).
217RA299 TG
1
2
: Push the grommet (1) out.
217RA181 TG
: Disconnect the impulse hose (1)
from the stub (arrow).
– Remove the handle housing.
217RA298 TG
1
: Unscrew the spring and bearing
plug.
217RA337 TG
: Screw the spring (1) and bearing
plug (2) into the new front handle.
– Install the complete handle
housing in the reverse sequence
of steps.
– Tightening torques, b 3.5
217RA336 TG
1
2
– Installation of rubber parts is
made easier by using STIHL
Press Fluid, b 16
To Next Page
Loading...
