MS 241 C-M
English
36
Cranking
N Pull the starter grip slowly with your
right hand until you feel it engage –
and then give it a brisk strong pull
and push down the front handle at
the same time. Do not pull out the
starter rope to full length – it might
otherwise break. Do not let the
starter grip snap back. Guide it
slowly back into the housing so that
the starter rope can rewind properly.
Machines without additional manual fuel
pump: If the engine is new or after a long
out-of-service period or if the tank has
been run dry (engine stops), it may be
necessary to pull the starter rope several
times to prime the fuel system.
Starting the Saw
WARNING
Bystanders must be well clear of the
general work area of the saw.
Versions with manual fuel pump
N Press the manual fuel pump bulb at
least five times – even if the bulb is
already filled with fuel.
Versions with decompression valve
N Press in the button to open the
decompression valve.
The decompression valve closes as
soon as the engine fires. For this reason
you must press in the button before each
starting attempt.
All models
N Push the hand guard (1) forward –
the chain is locked.
The Master Control lever (4) is in the
normal run position F.
N If the engine is cold: Press down the
trigger lockout (2) and pull the
throttle trigger (3) at the same time.
Hold both levers in that position and
set the Master Control lever (4) to
start symbol }.
N Hold your saw firmly.
N Pull the starter grip quickly and
firmly as often as necessary until the
engine starts.
N If the engine does not start: Move
the Master Control lever (4) to start
position } and repeat starting
procedure.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
