38
English
MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
At temperatures below +10°C/
50°F:
: Press down the throttle trigger
interlock and move the Master
Control lever to l (cold start).
: Turn the twist lock above the rear
handle 90° to the left.
: Lift off the carburetor box cover
vertically.
: Lift out the shutter (in front of spark
plug) vertically.
: Turn the shutter 180°.
: Refit the shutter.
: Refit the carburetor box cover and
secure it the twist lock.
Heated air is now drawn in from around
the cylinder and mixed with cold air –
this helps prevent carburetror icing.
At temperatures above +20°C/70°F,
always close the shutter again. This
is important to avoid engine running
problems, i.e. overheating.
The four positions of the
Master Control lever
$ = Engine off –
ignition is switched off.
# = Normal run position –
engine runs or can fire.
To move the Master Control lever from #
to
n or l, press down the throttle
trigger interlock and squeeze throttle
trigger at the same time.
n=Warm start – this position is used to
start a warm engine. The Master
Control lever moves to the normal
run position as soon as the throttle
trigger is squeezed.
l=Cold start – this position is used to
start a cold engine.
Winter Operation
208BA005 KN
135BA029 LÄ
Information
Before You Start
STOP
0
001BA140 KN
To Next Page
Loading...
