41MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
English
Machines with ErgoStart:
ErgoStart stores the energy required to
start the chainsaw. For this reason there
may be a delay of a few seconds
between cranking the engine and it
actually starting.
There are two ways of starting with the
ErgoStart:
: Hold the starter grip with your right
hand and pull it out slowly and
steadily
or:
Hold the starter grip with your right
hand and give it several short pulls,
using only a short length of rope for
each pull.
: Push down the front handle down
while cranking. Do not pull out the
starter rope to its full length – it
might otherwise break.
: Do not let the starter grip snap back
– guide it slowly and vertically into
the housing so that the starter rope
can rewind properly.
When engine begins to fire:
: Move Master Control lever (3) to n
and continue cranking – as soon
as engine runs, immediately blip
the throttle trigger (4) –
the Master Control lever (3) will
move to the “run” position # (5) and
the engine settles down to idling
speed.
.
As the chain brake is still engaged,
the engine must be returned to
idling speed immediately – or the
engine and chain brake might
otherwise be damaged.
: Pull the hand guard back toward
the front handle: =
The chain brake is now disengaged
– your saw is ready for operation.
Always disengage chain brake
before accelerating engine. High
revs with the chain brake engaged
(chain locked) will quickly damage
the engine and chain drive (clutch,
chain brake).
: Observe safety precautions.
: Always check operation of chain
lubrication before starting work.
3
4
5
0
208BA001 KN
143BA012 KN
To Next Page
