64
English
MS 210, MS 210 C, MS 230, MS 230 C, MS 250, MS 250 C
26 Rear Handle
The support handle for the right
hand, located at the rear of the saw.
27 Rear Hand Guard
Gives added protection to
operator's right hand.
Guide Bar Nose
The exposed end of the guide bar.
(not illustrated, see chapter
"Tensioning the Saw Chain")
Clutch
Couples engine to chain sprocket
when engine is accelerated beyond
idle speed (not illustrated).
Anti-Vibration System
The anti-vibration system includes a
number of buffers designed to
reduce the transmission of
vibrations created by the engine
and cutting attachment to the
operator's hands (not illustrated).
EPA / CEPA:
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
CARB:
The Emission Compliance Period used
on the CARB Air Index Label indicates
the terms:
Extended = 300 hours
Intermediate = 125 hours
Moderate = 50 hours
Engine
STIHL single cylinder two-stroke engine
MS 210
MS 230
MS 250
Magneto Ignition System
Electronic (breakerless)
Spark plug (resistor type)
Bosch WSR 6 F, NGK BPMR 7 A
Electrode gap
0.5 mm
This ignition system conforms to all
requirements of the Canadian
Interference-Causing Equipment
Regulations ICES-002.
Displacement 35.2 cm
3
Bore 40 mm
Stroke 28 mm
Engine power 1.5 kW
Idle speed 2800 rpm
Specifications
Displacement 40.2 cm
3
Bore 40 mm
Stroke 32 mm
Engine power 1.9 kW
Idle speed 2800 rpm
Displacement 45.4 cm
3
Bore 42 mm
Stroke 32 mm
Engine power 2.2 kW
Idle speed 2800 rpm
To Next Page
Loading...
