7MS 171, MS 181, MS 211
Remarks:
1) Loctite 243 medium strength
2) Degrease crankshaft/flywheel faces and mount oil-free
Use the following procedure when refitting a DG or P screw in an existing thread:
Place the screw in the hole and rotate it counterclockwise until it drops down slightly.
Tighten the screw clockwise to the specified torque.
This procedure ensures that the screw engages properly in the existing thread and does not form a new thread
and weaken the assembly.
Power screwdriver setting for polymer: DG and P screws max. 500 rpm
Do not use a impact wrench for releasing or tightening screws.
Do not mix up screws with and without binding head
To Next Page
Loading...
Need help?
General
