Stihl MS 280 C User Manual

27MS 280 C
English / USA
Bucking
Bucking is cutting a log into sections.
!Warning!
When bucking, do not stand on the log.
Make sure the log will not roll downhill. If
on a slope, stand on the uphill side of the
log. Watch out for rolling logs.
Cut only one log at a time.
Shattered wood should be cut very
carefully. Sharp slivers of wood may be
caught and flung in the direction of the
operator of the saw.
When cutting small logs, place log
through "V" - shaped supports on top of
a sawhorse. Never permit another
person to hold the log. Never hold the
log with your leg or foot.
Logs under strain:
Risk of pinching! Always start relieving
cut (1) at compression side.Then make
bucking cut (2) at tension side.
If the saw pinches, stop the engine and
remove it from the log.
Only properly trained professionals
should work in an area where the logs,
limbs and roots are tangled. Working in
“blow down“ areas is extremely
hazardous.
Drag the logs into a clear area before
cutting. Pull out exposed and cleared
logs first.
001BA033 KN
0
01BA051 LÄ
1
001BA151 KN
2
1
001BA152 KN
2

Stihl MS 280 C Specifications

General

Brand	Stihl
Model	MS 280 C
Category	Chainsaw
Language	English