41MS 361 C
English / USA
: Pull the starter grip slowly with your
right hand until you feel it engage –
and then give it a brisk strong pull
and push down the front handle at
the same time. Do not pull out the
starter rope all the way - it might
otherwise break. Do not let the
starter grip snap back – guide it
slowly and vertically into the
housing so that the starter rope can
rewind properly.
If engine is new or after a long out-of-
service period, it may be necessary to
pull the starter rope several times to
prime the fuel system.
When the engine begins to fire:
: Press in the decompression valve
button again.
: Move Master Control lever (4) to n
and continue cranking – as soon
as engine runs, immediately blip
the throttle trigger (5) –
the Master Control lever (4) will
move to the “Run” position # (6)
and the engine will settle down to
idling speed.
.
As the chain brake is still engaged,
the engine must be returned to
idling speed immediately – or the
engine housing and chain brake
might otherwise be damaged.
: Pull the hand guard back toward the
front handle:=
The chain brake is now disengaged
– your saw is ready for operation.
Always disengage chain brake
before accelerating the engine.
High revs with the chain brake
engaged (chain locked) will quickly
damage the engine and chain drive
(clutch, chain brake).
: Observe safety precautions.
: Check operation of chain lubrication
before starting work.
213BA006 KN
6
4
0
213BA007 KN
5
STOP
213BA008 KN
To Next Page
Loading...
Need help?
General
