Stihl MS 361 C User Manual

50
English / USA
MS 361 C
Starter Grip with ElastoStart*
: Use a screwdriver to pry the rope
out of the starter grip.
: Remove the remaining rope from
the rotor and grip.
: Thread the new rope through the
top of the starter grip.
* see “Guide to Using this Manual”
All Versions
: Thread the rope through the top of
the guide bush (5), pull it through
the rotor (6) and secure it with a
simple overhand knot.
: Coat rope rotor bearing bore with
resin-free oil.
: Slip rotor over the starter post (7) –
turn it back and forth to engage
anchor loop of the rewind spring.
: Fit the pawls (4) in the rope rotor.
: Fit the washer (3) on the starter
post.
: Use a screwdriver or suitable pliers
to install the spring clip (2) on the
starter post and engage it on the
pawls’ pegs – the spring clip must
point clockwise as shown in the
illustration.
Tensioning the Rewind Spring
: Make a loop in the starter rope and
use it to turn the rope rotor six full
revolutions in the direction of the
arrow.
213BA019 KN
6
7
213BA020 KN
5
4
4
3
2
001BA096 KN
213BA021 KN

Stihl MS 361 C Specifications

General

Brand	Stihl
Model	MS 361 C
Category	Chainsaw
Language	English