EasyManuals Logo

Stihl MS 440 User Manual

Stihl MS 440
127 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
28
English / USA
MS 440, MS 440 W, MS 440 C
Retensioning during cutting work:
: Shut off the engine first –
and then loosen the nut.
: Hold the bar nose up and use
screwdriver to turn tensioning screw
(1) clockwise until chain fits snugly
against the underside of the bar.
: While still holding the bar nose up,
tighten down the nut firmly.
: Go to chapter “Checking Chain
Tension”.
A new chain has to be retensioned more
often than one that has been in use for
some time.
: Check chain tension frequently –
see chapter "Operating
Instructions".
: Shut off the engine.
: Wear work gloves.
: Chain must fit snugly against the
underside of the bar – and, with the
chain brake disengaged, it must still
be possible to pull the chain along
the bar by hand.
: If necessary, retension the chain.
A new chain has to be retensioned more
often than one that has been in use for
some time.
Check chain tension frequently – see
"Operating Instructions".
This engine is certified to operate on
unleaded gasoline and the STIHL two-
stroke engine oil at a mix ratio of 50:1.
Your two-stroke engine requires a
mixture of brand-name gasoline and
quality two-stroke air cooled engine oil.
Use mid-grade unleaded gasoline with a
minimum octane rating of 89 (R+M/2). If
the octane rating of the mid-grade
gasoline in your area is lower, use
premium unleaded fuel.
Fuel with a lower octane rating may
increase engine temperatures. This, in
turn, increases the risk of piston seizure
and damage to the engine.
The chemical composition of the fuel is
also important. Some fuel additives not
only detrimentally affect elastomers
(carburetor diaphragms, oil seals, fuel
lines, etc.), but magnesium castings and
catalytic converters as well. This could
cause running problems or even
damage the engine. For this reason
STIHL recommends that you use only
nationally recognized name brand
unleaded gasoline!
Tensioning the Saw Chain
1
133BA024 KN
Checking Chain Tension
143BA007 KN
Fuel

Other manuals for Stihl MS 440

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Stihl MS 440 and is the answer not in the manual?

Stihl MS 440 Specifications

General IconGeneral
Displacement70.7 cc
Chain Pitch3/8"
Ignition systemElectronic
StarterRecoil starter
Vibration reductionAnti-vibration system
Weight (without bar and chain)6.4 kg
Fuel tank volume0.73 L
Oil Capacity0.36 L
Guide Bar Length40-63 cm
Guide Bar Length (recommended)40-71 cm (16-28 in)

Related product manuals