MS 441
English
30
Fitting the Cover Plate (special
accessory)
N Place the cover plate (1) in position,
engage the two tabs (arrows), and
secure it with the screws (2).
When the cover plate is fitted, the
shutter must be in the winter position.
N If your saw is very cold (frost or ice
on machine), start the engine and
keep it at a high idle speed (with
chain brake disengaged) until it
reaches normal operating
temperature.
In the event of engine running problems,
first move the shutter from the winter to
the summer position.
Switching on the handle heating
(depending on model)
N Move switch on front handle to F –
move switch back to 0 to switch off
the heating.
There is no risk of overheating during
long periods of operation. The heating
system is maintenance-free.
Positions of Master Control lever
Stop 0 – engine off – the ignition is
switched off.
Normal run position F – engine runs or
can fire.
Starting throttle n – this position is
used to start a warm engine. The Master
Control lever moves to the normal run
position as soon as the throttle trigger is
squeezed.
Choke shutter closed l – this
position is used to start a cold engine.
Electric Handle Heating Starting / Stopping the
Engine
STOP
0
001BA140 KN
To Next Page
Loading...
Need help?
General
