42 MS 460, MS 460 C
: Hold the crankshaft steady,
release the spindle counter-
clockwise and then unscrew the
service tool, also counter-
clockwise.
VA
176RA133
: Place new gasket on clutch side
of crankcase.
VA
176RA134
– Lubricate straight stub of
crankshaft with oil.
: Fit crankshaft stub in the ball
bearing.
VA
176RA135
: To prevent the crankcase
and gasket twisting, fit M5x72
screws (arrows) in two crankcase
holes and tighten them down as
far as stop.
– Screw the spindle (left-hand
thread) fully into the service tool
VA
176RA136
AS 5910 890 2205.
: Screw threaded sleeve (1)
5910 893 2409 of service tool AS
5910 890 2205 onto the spindle
as far as stop (left-hand thread).
VA
176RA137
1
– Push the threaded sleeve over
the crankshaft stub.
: Hold the crankshaft steady and
rotate the spindle counter-
clockwise to screw the threaded
sleeve onto the crankshaft.
VA
176RA138
– Release the crankshaft. Hold the
service tool steady and continue
turning the spindle until the tool
locates against the guide bar
mounting face.
– Fit the hex nut (for chain sprocket
cover) on the collar stud and
screw it down finger-tight.
: Turn the spindle counterclock-
wise until the crankshaft locates
against the ball bearing.
– Unscrew the hex nut.
VA
176RA139
145RA152
To Next Page
Loading...
