46 MS 460, MS 460 C
If the ignition lead or spark plug boot
is damage, install new parts,
b 7.2
– If necessary, pry peg of the wire
retainer out of the ignition
module.
: Remove the wire retainer.
– If necessary, install ignition lead,
b 7.2, before fitting wire retainer.
VA
176RA154
– Coat threads of screws with
Loctite 242, b 16, before
installing.
Secure ground wire under ignition
module’s right-hand mounting
screw.
: On machines with heated
handles, position the wire with
connector under the ignition
module and in the retainers
(arrows).
VA
176RA150
: Rotate the flywheel until the two
raised portions (arrow) are in line
with the ignition module.
VA
176RA155
: Slide the setting gauge (1)
1111 890 6400 between the arms
of the ignition module and the
raised edge of the flywheel.
– Press the ignition module against
the setting gauge.
VA
176RA156
1
– Tighten down the screws firmly,
b 3.5
– Remove the setting gauge and
use a feeler gauge to check the
air gap. It should be 0.2 mm.
– Reconnect the short circuit wire.
– Fit the shroud, b 6.4
Install all other parts in the reverse
sequence.
To Next Page
Loading...
