Stihl Mse 210 c User Manual

MSE 170 C, MSE 190 C, MSE 210 C, MSE 230 C
English
26
toward the bar nose – even if your left
hand is not behind the hand guard, e.g.
during a horizontal cut.
The chain brake will operate only if the
hand guard has not been modified in any
way.
Checking operation of the chain brake
Before starting work:
N Move hand guard to position ‚ –
chain brake is disengaged.
N Switch on the saw.
N Push the hand guard towards the
bar nose (position ƒ).
The chain brake is working properly if
the saw chain comes to a standstill
within a few fractions of a second.
The hand guard must be free from dirt
and move freely.
Chain brake maintenance
The chain brake is subject to normal
wear. It is necessary to have it serviced
and maintained regularly by trained
personnel. STIHL recommends that you
have servicing and repair work carried
out exclusively by an authorized STIHL
servicing dealer. Maintain the following
servicing intervals:
The voltage and frequency of the
machine (see rating plate) and the
voltage and frequency of your power
supply must be the same.
The mains connection must be
protected by a fuse with a minimum
rating in accordance with the
specifications – see "Specifications".
The unit must be connected to the power
supply via a ground-fault circuit breaker,
which interrupts the power supply to the
unit if the leakage current to ground
exceeds 30 mA.
The mains connection must comply with
IEC 60364-1 and country-specific
regulations.
When the machine is switched on,
voltage fluctuations that occur under
unfavorable mains conditions (high
mains impedance) may affect other
connected loads. Contact your local
electric utility for information on the
mains impedance. Connect your power
tool only to a suitable mains supply
system – for maximum permissible
mains impedance see "Specifications".
Extension cord
The design of the extension cord must at
least fulfill the same features as the
connecting cord on the machine.
Observe the design marking (type
designation) on the connecting cord.
The cores in the cord must have the
following minimum cross-section
depending on the mains voltage and
cord length.
Connecting to Wall Outlet
N Connect the power tool's plug or the
extension cord's plug to a properly
installed wall outlet.
Full-time usage: every 3 months
Part-time usage: every 6 months
Occasional usage: every 12
months
Connecting to Power Supply
Cord length Minimum cross-
section
220 V – 240 V:
Up to 20 m 1.5 mm
2
20 m to 50 m 2.5 mm
2
100 V – 127 V:
Up to 10 m AWG 14 / 2.0 mm
2
10 m to 30 m AWG 12 / 3.5 mm
2

Stihl Mse 210 c Specifications

General

Brand	Stihl
Model	Mse 210 c
Category	Chainsaw
Language	English