Stihl RMA 443.2 VC - Activating and Deactivating Bluetooth Radio Interface; Assembling the Lawn Mower

7 Activating and Deactivating
Bluetooth® Radio Interface
7.1
Activating the Bluetooth
®
Radio
Interface
►
If the battery is equipped with a Bluetooth
®
radio interface: press the button and hold it
depressed for about 3 seconds.
The "BLUETOOTH
®
" LED next to the sym‐
bol
lights up blue for about 3 seconds. The
Bluetooth
®
radio interface on the battery is
activated.
7.2
Deactivating the Bluetooth
®
Radio Interface
►
If the battery is equipped with a Bluetooth
®
radio interface: press the button and hold it
depressed for about 3 seconds.
The "BLUETOOTH
®
" LED next to the sym‐
bol flashes blue for six times. The Blue‐
tooth
®
radio interface on the battery is deacti‐
vated.
8 Assembling the Lawn
Mower
8.1 Attaching the Handlebar
► Switch the lawn mower off, pull out the activa‐
tion key and remove the battery.
► Place the lawn mower on a level surface.
► Press sleeve (1) into the bores in upper han‐
dlebar (2).
► Fit spring washers (3) with the convex side
facing inwards onto sleeve (1).
► Guide upper handlebar (2) into handlebar
bracket (4).
► Push bolt (5) through the bores in handlebar
bracket (4) and the sleeve in upper handle‐
bar (2).
► Place nut (6) in the notch in handlebar
bracket (4).
► Tighten bolt (5).
► Press cable (7) into holders (8).
► Fasten cable (7) to the handlebar using cable
clip (9).
The handlebar must not be dismantled again.
8.2 Assembling, Attaching and
Detaching the Grass Catcher
Box
8.2.1 Assembling the Grass Catcher Box
► Fit upper part of grass catcher box (1) onto
lower part of grass catcher box (2).
English 7 Activating and Deactivating Bluetooth® Radio Interface
36 0478-131-9948-D