0458-006-9621-A
38
English
4 Safety Precautions
4.9 Connecting to Power Supply
Contact with live components may occur for the following
reasons:
– The connecting cable or extension cable is damaged.
– Connecting cable plug or extension cable is damaged.
– Wall outlet is not properly installed.
DANGER
￭ Contact with live components can result in an electric
shock. This can result in serious or fatal injuries.
► Check that the connecting cable, extension cable and
their plugs are not damaged.
► Never touch the connecting cable, extension cable or
their plugs with wet hands.
► Insert the plug of the connecting cable or extension
cable in a properly installed fused wall outlet with
ground contact.
► Install the charger with a ground fault circuit interrupter
(30 mA, 30 ms).
￭ A damaged or unsuitable extension cable can cause an
electric shock. This can result in serious or fatal injuries.
► Use an extension cable with the correct wire gauge,
@ 18.4.
WARNING
￭ Overvoltage can occur in the charger if the line voltage or
frequency are incorrect during charging. The charger may
be damaged.
► Make sure the line voltage and frequency agree with the
data on the charger’s rating plate.
￭ A carelessly laid connecting or extension cable can be
damaged and cause others to trip or fall. This can result in
injuries and may damage the connecting cable or
extension cable.
► Position and mark connecting cable and extension
cable so they do not represent a trip hazard.
► Position the connecting and extension cables so that
they are not under tension or entangled.
► Position the connecting and extension cables so that
they cannot be damaged, kinked, pinched or chafed.
► Protect the connecting cable and extension cable from
heat, oil and chemicals.
► Lay the connecting and extension cables on a dry
surface.
If the connecting cable or extension cable is
damaged:
► Do not touch damaged areas.
► Disconnect the plug from the wall outlet.
To Next Page
Loading...
