Stihl Sr 420 - Page 32

31SR 340, SR 420
English / USA
: Ease the cap (6) out of the starter
grip.
: Remove remaining rope from the
rotor and grip.
: Tie a simple overhand knot in the
end of the new starter rope and then
thread the rope through the top of
the grip and the rope bushing (7).
: Refit the cap in the grip.
: Thread the rope through the rotor
and secure it in the rotor with a
simple overhand knot.
: Fit the pawl (5) in the rotor and slip
the washer (4) over the starter post.
: Use a screwdriver or suitable pliers
to install the spring clip (3) on starter
post and over the peg on the pawl –
the spring clip must point clockwise
– see illustration.
Go to “Tensioning rewind spring”.
353BA041 KN
7
6
373BA026 KN
353BA034 KN
3
5
4