SR 200
English
18
Cranking
N Place the unit securely on the
ground and make sure that
bystanders are well clear of the
nozzle outlet.
N Make sure you have a firm footing:
Hold the unit with your left hand on
the container and put one foot
against the base plate to prevent it
from slipping.
N Pull the starter grip slowly with your
right hand until you feel it engage
and then give it a brisk strong pull.
Do not pull out the starter rope to full
length – it might otherwise break.
N Do not let the starter grip snap back.
Guide it slowly back into the housing
so that the starter rope can rewind
properly.
N Continue cranking until the engine
runs.
Other Hints on Starting
If the engine stops while the choke knob
in on g or during acceleration
N Move the choke knob to < and
continue cranking until the engine
runs.
If engine does not start
N Make sure all settings are correct
(choke knob, setting lever in run
position F).
N Repeat the starting procedure.
If fuel tank has been run completely dry
and then refueled
N Press the manual fuel pump bulb at
least five times – even if the bulb is
filled with fuel.
As soon as the engine runs
N Operate the throttle trigger.
N Choke knob automatically returns to
the run position F when the throttle
trigger is operated.
At very low outside temperatures
N Open throttle slightly – warm up the
engine for a short period.
To Next Page
Loading...
