TS 700, TS 800
English
43
Maintenance and Care
The following maintenance intervals apply in normal operating conditions. The
specified intervals must be shortened accordingly when working for longer than
normal or under difficult cutting conditions (extensive dust, etc.).
Before starting work
At the end of work and/or
daily
Whenever tank is refilled
Weekly
Monthly
Yearly
If faulty
If damaged
As required
Complete machine
Visual inspection (condition, leaks) XX
Clean X
Operating elements Function tests XX
Manual fuel pump (if present)
Check X
Have repaired by a specialist dealer
1)
X
Fuel pickup body in fuel tank
Check X
Replace XXX
Fuel tank Clean X
Poly V-belt
Clean / retension XX
Replace XX
Air filter (all filter components) Change Only if there is a noticeable loss of engine power
Cooling air intake slits Clean X
Cylinder fins
Have them cleaned by a servicing
dealer
1)
X
Spark arresting screen
2)
in muffler
Check X
Clean or replace X
Water attachment
Check XX
Have them maintained by a servicing
dealer
1)
X
Carburetor
Check idle adjustment – abrasive
wheel must not rotate
XX
Readjust idle speed X
Spark plug
Adjust electrode gap X
Replace after 100 hours operation
All accessible screws, nuts and bolts (not
adjusting screws)
Retighten XX
To Next Page
Loading...
