To Next PageTo Next Page
Need help?Do you have a question about the Stihl TS 410 and is the answer not in the manual?
General| Cutting Wheel Diameter | 300 mm |
|---|---|
| Fuel Tank Capacity | 0.71 L |
| Idling Speed | 2, 500 rpm |
| Displacement | 66.7 cm³ |
| Engine Power | 3.2 kW |
Information regarding the operator's physical and mental condition.
Requirements for the operator's physical and mental state.
Recommendations for appropriate protective clothing.
Safety precautions and guidelines for using abrasive wheels.
Characteristics and considerations for diamond abrasive wheels.
Information on the correct fuel mixture for the engine.
Understanding and preventing reactive forces and kickback.
Explanation of common reactive forces and kickback scenarios.
Importance of cutting sequence for openings and recesses.
Techniques for cutting thicker materials in multiple passes.
Details on composite resin wheels, types, and materials.
Importance of proper spindle bearing for wheel performance.
Troubleshooting specific issues related to cutting wheels.
Explanation and prevention of undercutting on diamond wheels.
Identifying and addressing built-up edges on cutting wheel segments.
Description of the electronic water control panel buttons.
Instructions for activating and adjusting the water flow.
Steps for safely fitting and replacing abrasive cutting wheels.
Step-by-step instructions for fitting a new cutting wheel.
How to open the fuel filler cap safely.
How to properly close the fuel filler cap.
Step-by-step guide for starting the cut-off machine engine.
Initial starting procedure after the engine has turned over.
Actions to take once the engine has started.
Tips for troubleshooting starting issues.
Instructions for replacing the air filter when performance is affected.
Checking and adjusting the carburetor settings.
Testing and replacing abrasive wheels.
