Stihl TS 700, TS 800 User Manual

STIH)
STIHL TS 700, 800
2012-06

Stihl TS 700, TS 800 Specifications

General

Brand	Stihl
Model	TS 700, TS 800
Category	Saw
Language	English

Summary

2. Safety Precautions

3.6 Tightening Torques

4. Troubleshooting

4.1 Clutch Troubleshooting

Troubleshooting guide for clutch-related problems and their remedies.

4.2 Rewind Starter Troubleshooting

4.3 Ignition System Troubleshooting

4.4 Carburetor Troubleshooting

4.5 Power Unit Troubleshooting

5. Abrasive Wheel Drive

6. Clutch

7. Power Unit

7.2 Leakage Test

7.2.2 Pressure Test for Leaks

7.2.3 Vacuum Test for Leaks

7.3 Oil Seals Replacement

7.6 Cylinder and Piston Procedures

7.6.1 Cylinder Removal

Steps to remove the cylinder.

7.6.2 Cylinder and Piston Installation

7.8 Crankcase and Crankshaft

7.8.1 Crankcase and Crankshaft Removal

Steps to remove the crankcase and crankshaft.

7.8.2 Crankcase and Crankshaft Installation

8. Ignition System

8.1 Ignition Module

Procedures related to the ignition module.

8.1.1 Ignition Module Removal and Installation

8.3 Testing the Ignition Module

8.5 Flywheel Removal and Installation

8.7 Ignition System Troubleshooting Chart

9. Rewind Starter

9.7 Replacing the Rewind Spring

10. Repairing the AV System

11. Actuating Levers

12. Fuel System

12.2 Carburetor Removal and Installation

12.2.1 Carburetor Removal and Installation Steps

12.2.2 Carburetor Leakage Testing

12.3 Carburetor Repair

12.3.1 Metering Diaphragm Replacement

Steps for removing and installing the metering diaphragm.

12.3.2 Inlet Needle Removal and Installation

12.3.4 Pump Diaphragm Replacement

12.3.5 Choke Shaft and Choke Shutter Service

12.3.6 Throttle Shaft and Throttle Shutter Service

12.3.7 Air Flap Shaft and Air Flap Service

12.3.8 Air Flap Rod Removal and Installation

12.3.9 Adjusting the Air Flap Rod

12.4 Carburetor Adjustment

12.4.1 Basic Setting of Carburetor

Steps to perform the basic setting of the carburetor.

13. Special Tools

Special Tool: Carburetor and Crankcase Tester

Tool for testing crankcase and carburetor for leaks.

Special Tool: Ignition System Testers

Tools for testing the ignition system.

Special Tool: Torque Wrench