Stihl TS 700, TS 800 - 12.2 Carburetor Removal and Installation; 12.2.1 Carburetor Removal and Installation Steps

67TS 700, TS 800
: Pull the auxiliary filter (1) out of
the filter base.
– Check the auxiliary filter and
replace it if damaged or dirty.
1
376RA130 TG
: Examine gasket (arrow) in filter
housing and replace it if
necessary.
– Reassemble remaining parts in
reverse order.
– Tightening torques, b 3.6
376RA131 TG
– Remove shroud, b 7.4
– Remove the air filter, b 12.1
– Close the choke shutter on the
carburetor.
: Unscrew the nuts (1) on the
carburetor.
: Undo the screws (2).
2
2
1
1
376RA146 TG
: Pull the air hose (1) off the filter
base.
: Disconnect the compensator
hose (2) and fuel pump intake
hose (3) from the carburetor.
376RA147 TG
1
2
3
: Disconnect the tank vent hose (1)
and return hose (2) to the fuel
pump.
– Examine the hoses and replace
them if necessary.
376RA148 TG
1
2
If there are leaks in the tank
housing, these may also be due to a
defective rubber grommet.
: Prise off the rubber grommet (1)
with a suitable tool.
1
376RA204 TG
: Press the rubber grommet (1)
into the hole in the tank housing
until the rubber lip lies tightly
against the housing.
1
376RA205 TG
12.1.1 Air filter base