Stihl TS 700, TS 800 - 5 Abrasive Wheel Drive; Bearing with Guard

15TS 700, TS 800
– Test radial and axial truth of
running, b 5.2
: Release hose clip (1), remove
hose retainer (2) and disconnect
hose (3).
During installation, ensure that the
2
1
3
376RA001 TG
hose clip (1) does not touch the
handlebar.
: Relax the ribbed V-belt by turning
the hexagon of the tensioner
anticlockwise until the arrow
points to the left (to "0").
376RA003 TG
: Remove screws (1) from bearing
and remove guard.
376RA004 TG
1
1
: Unhook the ribbed V-belt (1) from
the belt pulley and remove the
bearing with guard.
1
376RA017 TG
: Remove screw (1) from the thrust
washer (2).
– Remove the thrust washer.
2
338RA005 VA
1
: Remove axial clamping ring from
the shaft.
: Remove thrust washer (1).
1
376RA016 TG
: Block the belt pulley (arrow).
: Unscrew the nut (left-hand
thread) and remove the belt
pulley.
376RA018 TG
: Remove the key (1) from the
groove in the shaft.
: Remove the washer (2) from the
shaft.
2
1
376RA012 TG
5. Abrasive wheel drive
5.1 Bearing with guard