Stihl TS 700, TS 800 - Ignition Lead; Spark Plug Boot

45TS 700, TS 800
– Remove the fan cover, b 7.5
– Remove the ignition module,
b 8.1.1
– Unplug the spark plug boot.
376RA354 TG
: Pull the grommet (1) off the high-
voltage output (2).
: Unscrew the ignition lead (3) from
the contact pin and pull it out of
the high-voltage output.
: Pull the grommet off the ignition
1
2
3
376RA139 TG
lead.
: Use suitable pliers to pull the leg
spring out of the spark plug boot.
– Unhook the leg spring from the
ignition lead.
– Pull the boot off the ignition lead.
VA
212RA236
– Cut the new ignition lead to a
length of 295 mm.
– Use a pointed tool to pierce the
centre of the lead's insulation
about 15 mm from the end of the
ignition lead.
: Pinch the hook of the leg spring
into the centre of the ignition lead
(arrow).
376RA136 TG
– Coat the inside of the spark plug
boot with
Press Fluid, b 14
: Push the ignition lead and leg
spring into the spark plug boot.
376RA136 TG
: Use a pointed tool to pierce the
other end of the ignition lead,
which is to be connected to the
ignition module.
– Refit the grommet.
– Pack the high-voltage output with
VA
176RA162
STIHL multi-purpose grease,
b 14
Note:
Do not use either graphite grease or
silicone insulating paste.
– Screw the ignition lead into the
ignition module.
– Push the grommet over the high-
voltage output.
8.4 Ignition lead /
spark plug boot